Configure a standalone NTP server in Windows Server. The use case is rare, but what do you do for a time server when Active Directory isn't available and a number of computers (which may or may not be Windows) have a single authoritative time source? The answer is Network Time Protocol (NTP), but configuring it outside of Active Directory is slightly different. Read my tip on configuring a time server within Active Directory domain controllers.). When a Windows Server makes the transition to being a domain controller, the capability of functioning as an NTP server comes online. Within the Windows Registry, the HKLM | System | Current.
Control. Set | Services | W3. Time | Time. Providers | Ntp. Server section has the configuration for the local NTP server. A default installation of Windows Server 2. R2 shows this in Figure A. Note: Editing the registry is risky, so be sure you have a verified backup before saving any changes.).
Applies To: Windows Server 2008 R2, Windows Server 2008, Windows Server 2003 with SP2. Enable Windows NTP Client here. Enable Windows NTP Server here. Which NTP-server to use? Or several? http:// Max Outstanding Disk Requests.
. Windows Server to function as an NTP. Configure a standalone NTP server in Windows. installation of Windows Server 2008 R2.
- Synchronize time with external NTP server on Windows Server 2008. 89 Comments on Synchronize time with external NTP server on Windows Server. Default Reasoning.
- The service is installed and enabled by default during installation. Windows synchronizes. Microsoft Windows Server 2008. with an external NTP server requires.
Figure AClick the image to enlarge. In Figure A, the "Enabled" registry value is off at a value of 0, indicating that the NTP server is not running on the computer. If you change the value to 1 and enter w.
Ntp Server Installation Windows 2008 Support
W3. 2TM, the Windows Time engine. In addition, if you run w.
NTP server (Figure B). Figure BClick the image to enlarge. Now you can configure other devices to use the NTP server configuration on this computer, and no Active Directory permissions are required.
This is different than using the net time command, which does not use NTP. Read this MSDN blog post for more information on the configuration process. Have you had to turn on NTP for standalone servers? If so, what additional steps did you take? Share your comments in the discussion.